how to install power pole guy wire anchors system

Power Pole Guy Wire Anchors System Series With The
Power Pole Guy Wire Anchors System Install Another One

Power Pole Guy Wire Anchors System Install Another One

Utility company wants to remove the guy wire and install another one on the right side.

Is there a reason why the guy wire needs to be on one side of the pole vs.

I would not see the need for a change unless they are changing the configuration of wires that attach to the pole or if it is a pole that they wires pass through in one direction, they may need to change it to correct instability side to side.

The bottom end is connected with a shackle directly to the RCS guy anchor extension.

A come-a-long is conveniently attached to the lifting eye and to the guy wire and the guy tensioned to remove the slack.

A preformed helical wire wrap is inserted through the eye on the top end and assembled onto the guy wire.

An anchor wrench fits over the square hub and a torque measurement device is required to determine proper installation.

Correct installation is achieved only when the anchor is installed using the appropriate torque for the particular soil and anchor type.

Power Pole Guy Wire Anchors System Series With The

Installation torque is usually measured using a device connected in series with the wrench, digger, and Kelley Bar during installation.

Proper anchor selection depends on the type of soil and guying requirements.

Anchors are painted with rust inhibiting blue paint after fabrication.

Installation is performed using a drive wrench which fits into the anchor hub.

Correct installation is achieved only when the anchor is installed using the appropriate torque for the particular soil and anchor type (see reference charts).

Installation torque is usually measured using a device connected in series with the wrench, digger, and Kelly Bar during installation.

How To Install Power Pole Guy Wire Anchors System